Go
All Results Based on Water Viscosity.

N9206

The carbonator motor mounting uses a circular clamp, similar to a hose clamp, as means of attaching the pump to a specially machined hub on the motor. This concept was first developed for the vending machine industry to pump carbonated beverages in soft drink dispensers. The main advantages are compactness and economy due to the elimination of the adapter casting. Carbonator motors are readily available from electric motor distributors. 

The rotary gear pump features an all bronze design and 303 stainless steel shafts with options of non-metallic gears and a variety of shaft seals. The built-in relief valve is available in multiple options; internal recirculation to suction side or external connection for return line to supply tank. 

FEATURES

  • Rugged corrosion resistant bronze construction
  • Compact close-coupled carbonator motor mount design
  • Stainless steel shafts
  • Durable bronze helical gears provide quiet operation
  • Process lubricated carbon graphite bearings
  • O-ring cover seal for maximum leak protection
  • Nitrile Mechanical Seal (fluoroelastomer optional)
  • Bronze TEE Coupler

DRIVE

Intended for close-coupled mounting to NEMA 48 Carbonator Mount footed motors using clamp and T coupling. Pump can be mounted in any orientation relative to the motor base. For vertical installations, mount pump below motor. Complete pump / motor units are available.

LIQUIDS & TEMPERATURES

Bronze pumps are suitable for water, oil, and mild chemicals in the pH-range from 4-10. Viscous liquids may be handled with carbonator pumps up to a viscosity of 300 SSU. Higher viscosities require a pump speed lower than 1725 RPM, which is currently not available in carbonator motors.

SUCTION LIFT

For a first start-up, the pump should be primed to avoid dry running. Gear pumps are self-priming, but a foot valve with strainer is recommended at the beginning of the suction line. This will keep the gear chamber primed to insure instant flow when the pump is started. Maximum suction lift is 20 feet. The suction line should be as short as possible.

PERFORMANCE

N9206 Curve

EXPLODED VIEW & PARTS LIST

N92060GRN9206 Series CUT SHEET Parts

DIMENSIONS

N9206 dimentions

ROTATION AND RELIEF VALVE

The relief valve is not intended to be a metering or flow control device. Its main purpose is to function as a discharge pressure relief when the spring tension is exceeded by the discharge pressure. Overheating can occur within 5-10 minutes if the discharge line is completely shut off for extended periods. 

Unless otherwise specified, the pump motor unit is supplied by the factory for shaft rotation clockwise from shaft end. Reversing the motor rotation will reverse the “in” and “out” ports and also requires changing the relief valve location. The relief valve is always on the inlet side in this pump series. The factory pressure setting is 50 PSIG. To increase pressure, turn the relief valve adjusting screw in a clockwise direction. To reverse single phase motors, find instructions on the inside of the junction box cover or on the nameplate of the motor.