Go
All Results Based on Water Viscosity.

C992T

The pumps are tailored specifically for wear resistance and long life in both lubricating C992T and non lubricating C992T-F service.  They are designed to handle a wide range of fluids at temperatures to 200F.  The operating pressure limit for thin fluids, i.e. 33 SSU, is 75 psi at 1725 RPM an 65 psi for viscous 200 SSU fluids based upon the 1.3 HP motor configuration.

These external gear pumps require less maintenance than comparable internal gear pumps primarily due to the absence of cantilevered bearing loads. Four sleeve bearings provide uniform shaft support on both sides of gears. As with all external gear rotary pumps which operate based upon close running clearances, the presence of solid particles and abrasives can lead to premature wear and damage. Use suction screens or start-up strainers when necessary.

FEATURES

  • Compact Dimensions
  • Rugged Ductile Iron Construction
  • Hardened Steel Shafts
  • Fluoroelastomer Lip Seal
  • Self-Lubricating Carbon Bearings (Optional Flanged Bearings C992T-F)
  • O-Ring Cover Seal for Maximum Leak Protection
  • Durable Paint Finish
  • Drop-In Replacement for Haight Model 5E001000

DRIVE

The C992T pump head features a male mounting hub and tanged drive shaft. It mounts directly to specifically modified 56Y frame motors - Oberdorfer™ F33 Part 2143 or Haight's (Leeson) M4C17DH66F . Our F33 motor is 60/50 HZ (4 Pole) ODP with capacitor start and rigid base.

LIQUIDS & TEMPERATURES

These pumps are suitable for all liquids that are compatible with bronze. Most common liquids are water, oil, and mild chemicals in the pH-range of 4 to 11. Viscous liquids require reduced shaft speeds of 1150 RPM or lower. Consult factory. Liquids containing solids, abrasives, powders or paint pigments are definitely not recommended for gear pumps. If abrasives are unavoidable, use a very low shaft speed. The recommended liquid temperature range is 32oF to 140oF for longest pump life. If more extreme temperature conditions exist, our factory should be consulted. Freezing of water-filled pumps can cause damage and must be avoided. Oils at low temperatures are very viscous requiring a lower speed or extra power.

SUCTION LIFT

Whenever possible, place the pump at an elevation below the liquid source. However since these positive displacement external gear pumps will generate 20" HG lift, this is not a requirement. As a general rule, place the pump as close to the liquid source as possible. For a first start-up, the pump should be primed to avoid dry running. Minimum size of the suction pipe is the size of the pump inlet port.

PERFORMANCE

C992T Curve

EXPLODED VIEW & PARTS LIST

C992T Sectional View W MotorC992T Sectional ViewC992T Parts Matrix

DIMENSIONS

C992T Dimension 1C992T Dimension 2

ROTATION AND RELIEF VALVE 

These pumps are bidirectional. The standard pump motor unit is set up for normal rotation (clockwise when viewing the pump from the shaft end). Reversing the motor rotation will reverse the "in" and "out" ports.

These pumps are positive displacement devices capable of generating high line pressure. Discharge lines should be fitted with properly sized line pressure relief valves to protect the pump, motor, and downstream system. The relief outlet should be piped back to the suction vessel.