Go
All Results Based on Water Viscosity.

101M

These pump housings and mounting brackets are made from cast aluminum or bronze alloy. The rotor is made from stainless steel with a hard chrome plate for improved wear properties. The stator is made from molded Nitrile. The mechanical seal is a carbon and ceramic mechanical rotary face type for positive sealing.

The turning of the helical shaped rotor within the stationary stator creates a progressing cavity similar to a moving piston. Liquid is thus displaced generating a pumping action. Unlike piston pumping, extremely high pressure cannot be created because the stator is made of Nitrile and is flexible. Because of this flexibility contaminated liquids can be handled. High starting torque motors are recommended in order to overcome the high starting friction of the stator. The pump is relatively quiet.

FEATURES

  • All Bronze or Corrosion Resistant Aluminum Construction
  • Easily Mounted in Field to Your Own 56 Frame
  • Motor & 56C For Explosion-Proof Motors
  • Carbon Face Mechanical Seal
  • Quiet Running
  • Can Handle Contaminated Liquids
  • Nitrile Stator and Stainless Steel Rotor

LIQUIDS & TEMPERATURES

 The corrosion resistant alloys used are compatible with common liquids including water, water solutions, oils and many commercial chemicals. Severe solvents are not compatible with the Nitrile and should not be pumped.

SUCTION LIFT

These centrifugal pumps are not self-priming. They must be  installed below the liquid level so that the liquid flows to the  pump by gravity (flooded suction). However, if a foot valve is  used at the beginning of the suction line, and all air is bled  from the pump by manual priming, the pump will lift on the  suction side up to 15 feet. Such a system relies entirely on the  non-leaking foot valve for starting capability.

PERFORMANCE

101M, 500 curve

EXPLODED VIEW & PARTS LIST

101M expl

101 Charts _WE Motors
101 Charts _WE Numbering101 Charts _WE Parts

DIMENSIONS

101 dim

ROTATION 

This helical rotor design demands a single rotation - clockwise when facing the pump drive shaft. Pump rotation and “in” and “out” ports are indicated on the dimension diagrams. 

ELECTRIC MOTOR MOUNTING

This pump is supplied close coupled to electric motor or as a pump alone complete with attaching parts and instructions for mounting. Any 56 frame electric motor (or 56C frame) with 5/8 inch shaft diameter, 1725 R.P.M. and of horsepower rating as listed can be used. The motor can be rigid or resilient mounted, sleeve or ball bearings, 50oC rise, capacitor start, counter-clockwise, rotation from shaft end. (For Gas Engine version, see models 111-UGY/111B-UGY) (FOR PERFORMANCE AT REDUCED MOTOR SPEEDS, SEE MODEL 121/121B)